User's Manual

2-36
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
...........................................................................................................................................................................................................................................................
Modular Cell 4.0B and WNG24-BC cabinet handling,
placement, anchoring and grounding
Important! When performing the next step, use care not to bend
or otherwise damage the side wall of the existing cabinet, which
can result in failure of the subsequently installed conduit seal to
prevent water leakage. Use a slow, careful rocking motion to
remove the knockout.
................................................................................................................................
............................................
3 Remove the AC port knockout from the lower-right side, near the front
of the existing cabinet (viewed from the front), shown shaded in the
figure below.
................................................................................................................................
............................................
4 Remove the square panel from the right side, near the front of the cabinet
(viewed from the front), shown shaded in the figure below.
RIGHT SIDE VIEW
REMOVE ROUND
AC PORT
KNOCKOUT
PREVIOUS CABINET*
* MODULAR CELL 4.0B PRIMARY CABINET OR FIRST BATTERY
CABINET (IF INSTALLING SECOND BATTERY CABINET)
REMOVE SQUARE
PANEL