User's Manual

Modular Cell 4.0B and WNG24-BC cabinet handling,
placement, anchoring and grounding
2- 37
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
............................................................................................................................................................................................................................................................
Prepare the cabinet being
installed for attachment to
the existing cabinet
Use the following procedure to prepare the battery cabinet for
attachment to the existing cabinet.
................................................................................................................................
............................................
1 Open the front door of the cabinet being installed. Refer to the figure on
Page 2-35.
Important! When performing the next step, use care not to bend
or otherwise damage the side wall of the existing cabinet, which
can result in failure of the subsequently installed conduit seal to
prevent water leakage. Use a slow, careful rocking motion to
remove the knockout.
................................................................................................................................
............................................
2 Remove the AC port knockout from the lower-left side, near the front of
the cabinet to be installed (viewed from the front), shown shaded in the
figure below.
................................................................................................................................
............................................
3 Remove the square panel from the left side, near the front of the cabinet
(viewed from the front), shown shaded in the figure below.
LEFT SIDE VIEW
REMOVE ROUND
AC PORT
KNOCKOUT
FIRST OR SECOND BATTERY CABINET
REMOVE SQUARE
PANEL