User's Manual
2-40
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
...........................................................................................................................................................................................................................................................
Modular Cell 4.0B and WNG24-BC cabinet handling,
placement, anchoring and grounding
Move/lift the cabinet being
installed into position
WARNING
Personnel injury or equipment damage
Cabinets are too heavy to move without appropriate lifting
devices. When moving the cabinet, use appropriate lifting
devices and a sufficient number of personnel.
Perform the following steps to position the cabinet being installed.
................................................................................................................................
............................................
1 If installing directly to a concrete surface, remove tape and any debris
covering the anchor holes.
................................................................................................................................
............................................
2 Place cabinet into the approximate position on mounting bases or on
concrete, over the anchor holes or the set anchors.
Important! When performing the next step, align the AC feed-
through conduit with the port opening in the wall of the existing
cabinet. Refer to the figure on Page 2-41. Also, use care not to
damage any wires located in the lower right front of the existing
cabinet.
................................................................................................................................
............................................
3 Position the cabinet approximately 10 mm away from the existing
cabinet, while at the same time inserting the AC feed-through coupling
through the wall of the existing cabinet.
................................................................................................................................
............................................
4 Align the cabinet with the anchor holes in the mounting surface or the
holes in the mounting bases, as applicable.
Important! If installing on mounting bases, you must
immediately install the bolts that secure the cabinet to the base. Do
not torque the bolts at this time.