User's Manual

ManualsBrandsAlcatel-Lucent USA ManualsElectronicsUMTS-CDMA Transceiver System (850)

A- 9

Lucent Technologies – Proprietary

See notice on first page

401-703-454

FOA Draft Issue 1

January, 2006

............................................................................................................................................................................................................................................................

How to place and attach the EZBFo battery base module outer frame

and mark, drill, and set anchors

Overview

In this module the installer will perform the following procedures:

• Unstrap the front panel and place it on the top panel of the outer

frame, not detaching the lanyard cable

• Attach the conduit to the battery base module outer frame

• Place the battery base module outer frame into position with the

conduit into the Modular Cell cabinet and attach conduit

• Remove the top and filter panels, not detaching the lanyard cable

• If anchor holes have not been drilled:

• Mark the anchor holes

• Detach conduit at Modular Cell cabinet, move the battery

base module outer frame aside, and drill the anchor holes

• Reposition the battery base module outer frame with the

conduit into the Modular Cell cabinet and attach the conduit

to Modular Cell cabinet

• Set the 1/2 inch drop in anchors

This module contains the following procedures:

Before you begin

If installing a EZBFo battery add-on module only, proceed to How to

install an EZBFo battery add-on module on an existing EZBFo battery module

on Page A - 76 to continue the installation. If installing an EZBFo

battery base module, continue as instructed.

Important! If the Modular Cell cabinet is equipped with

internal batteries, disconnect the battery connector or connectors

inside of the cabinet before proceeding.

Place and attach a battery base module to the Modular Cell cabinet

or the first battery base module using the applicable conduit

A - 10

Remove the top and filter panels from the battery base module A - 14

Mark and drill the anchor holes A - 16

Set the 1/2-inch diameter drop-in anchor A - 18