User's Manual

A- 10
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
...........................................................................................................................................................................................................................................................
Place and attach a battery
base module to the
Modular Cell cabinet or the
first battery base module
using the applicable
conduit
Perform the following steps to place and attach the outer frame of a
battery base module to the Modular Cell cabinet or the first battery base
module using the applicable conduit. The outer frame may have a front
panel or a door. The front panel is shipped shrink-wrapped to the front
of the outer frame with the lanyard cable attached between them.
Important! Note that the base module may be mounted directly
on a concrete pad. Procedures for the preparation of other types of
mounting surfaces are the responsibility of the customer.
................................................................................................................................
............................................
1 Skip the next step if the battery module is equipped with a front door
instead of a front panel.
................................................................................................................................
............................................
2 Unwrap the front panel from the front of the outer frame and place it on
the top of the frame. Do not disconnect the lanyard cable between the
front panel and the outer frame. Refer to the figure on Page A - 11
................................................................................................................................
............................................
3 If applicable, loosen the eight quarter-turn screws and open the front
door of the module. Refer to the figure below. Refer to the figure on
Page A - 11 for screw locations.
................................................................................................................................
............................................
4 Check the bottom plate for the “F” front orientation marker. If it is not
in the correct location the bottom panel must be removed and
repositioned correctly. Refer to the figure on Page A - 16
Note that the
front door may
be mounted wi
th
the hinges on
the right side,
instead of on t
he
left as shown.
The Intrusion
Alarm switch
is
always mount
ed
on the side
opposite
the
h
inges.