User's Manual

7-14
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
...........................................................................................................................................................................................................................................................
Finishing the installation
................................................................................................................................
............................................
6 Slide the boot towards the cabinet and install it into the opening on the
antenna cover. Refer to the figure below.
................................................................................................................................
............................................
7 Turn the boot so that the split is at the bottom of the cable.
................................................................................................................................
............................................
8 Ensure that the lip of the boot is fully seated in the antenna cable cover.
................................................................................................................................
............................................
9 Tape the small end of the boot as shown in the figure below.
................................................................................................................................
............................................
10 Repeat Steps 2 through 9 for all antenna jumper cables.
................................................................................................................................
............................................
11 Torque the antenna jumper cable connections to 221 in.-lb. (25 Nm).
Refer to Step 11 on Page 7 - 11 for the correct method
................................................................................................................................
............................................
12 Replace the top panel on the antenna cable cover. Torque the tamper-
E ND OF STEPS
................................................................................................................................
.............................................
proof screws to 15-20 in.-lb. (1.7 - 2.3 Nm).
Tape Here
SIDE VIEW
Connector
R
F Antenna Cable
Cable Boot