User's Manual

A- 14
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
...........................................................................................................................................................................................................................................................
Remove the top and filter
panels from the battery
base module
Perform the following steps to remove the top and filter panels from the
battery base module
Important! When performing the next two steps do not
disconnect the lanyard cable between the front and top panels and
the outer frame.
................................................................................................................................
............................................
1 If applicable, move the front panel off of the top panel and place it on
the left side of the outer frame. Refer to the figure below.
Important! When performing the next step, use the supplied TR
25 Keytorx bit and a driver.
................................................................................................................................
............................................
2 Remove the two TR 25 Keytorx screws from the front of the top panel.
Refer to the figure below.
................................................................................................................................
............................................
3 Slide the top panel slightly to the rear, lift the front of the panel up two
to three inches, and lift it off of the outer frame Place it beside the front
panel on the left side of the outer frame as shown in the figure below.
TOP PANEL
MODULAR
CELL
CABINET
or
FIRST
BATTERY
BASE
MODULE
BATTERY
BASE
MODULE
F
RONT PANEL
(
IF APPLICABLE)
LANYARD
CABLES
FILTER
PANE
L
FRONT VIEW
SCREW LOCATIONS