User's Manual

A- 15
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
............................................................................................................................................................................................................................................................
................................................................................................................................
............................................
4 Disconnect the top panel lanyard cable from the outer frame. Refer to
the figure on Page A - 14. Ensure that the top panel in a secure location.
................................................................................................................................
............................................
5 Remove the filter material from the filter panel. Refer to "A" in the
figure below.
................................................................................................................................
............................................
6 Remove eight bolts from the filter panel and remove the panel. Refer to
"B" in the figure below.
................................................................................................................................
............................................
7 Store the filter material and filter panel is a secure location.
Important! If the anchor holes have been drilled during site
preparation, skip to
Set the 1/2-inch diameter drop-in anchor on Page
A - 18 and follow the instructions to continue the installation from
that point. If the anchor holes have not been drilled during site
preparation, continue from this point.
FILTER MATERIAL
FILTER PANEL
A
B
TOP VIEW
BOLT LOCATIONS (2 of 8)