User's Manual

A- 17
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
............................................................................................................................................................................................................................................................
................................................................................................................................
............................................
3 From the inside and outside of the Modular Cell cabinet or the first
battery base module, as applicable, remove the chase nipple with
locknut and the sealing ring installed previously in Step 15 and Step 14
on Page A - 13. Refer to the figure on Page A - 13
................................................................................................................................
............................................
4 Move the battery base module aside (exercise care since the front panel
remains placed on the top panel).
................................................................................................................................
............................................
5 Drill the anchor holes (four or eight) to the proper size and depth as
specified in Anchor and hole size requirements on Page A - 8. Refer to the
figure below for the anchor hole drilling method.
................................................................................................................................
............................................
6 Vacuum out the holes as shown in the figure below.
1
2
3
DEPTH
GAUGE
ANCHOR