User's Manual

A- 18
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
...........................................................................................................................................................................................................................................................
................................................................................................................................
............................................
7 Replace the outer frame with the conduit into position beside the
Modular Cell cabinet (or first battery base module) with the conduit
against the associated opening. Refer to the figure on Page A - 13
................................................................................................................................
............................................
8 Place a sealing ring, “box side” facing left, at the left end of the conduit.
Refer to the figure on Page A - 13
................................................................................................................................
............................................
9 From the inside of the Modular Cell cabinet or the first battery base
module, as applicable, insert a chase nipple with locknut through the
right side frame and the sealing ring and into the conduit. Tighten the
chase nipple and lock nut. Refer to the figure on Page A - 13
Set the 1/2-inch diameter
drop-in anchor
Use the following procedure to install the 1/2-inch diameter drop-in
anchor.
................................................................................................................................
............................................
1 Tap in the four or eight anchors.
................................................................................................................................
............................................
2 Set the anchors using the setting tool. Refer to the figure below.
................................................................................................................................
............................................
3 Do not install the anchor bolts at this time.
SETTING
TOOL
BASE PLATE
OF BATTERY
BASE MODULE