User's Manual

A- 21
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
............................................................................................................................................................................................................................................................
Install the internal AC
wiring for the heater pads
This procedure module provides instructions on how to install the AC
wiring for the heater pads the battery module.
Important! The following steps must be performed prior to the
placement of the inner frame into the outer frame (base module) or
outer frame over the inner frame (add-on module).
................................................................................................................................
............................................
1 Locate the AC wire harness. Refer to the figure below.
................................................................................................................................
............................................
2 Locate the AC terminal block assembly. Refer to the figure below.
L1/L
L2/N
HEAT
PAD
CONNECTOR
(1 of 2)