User's Manual

A- 23
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
............................................................................................................................................................................................................................................................
................................................................................................................................
............................................
5 Secure the wire harness to the side panel with the supplied plastic self
stick anchors and cable ties.
................................................................................................................................
............................................
6 Loosen the indicated screws and insert the L1 and L2 two wire ferrules
into the top rear connections of the AC terminal block as shown in the
figure below. Tighten the indicated screws. Torque to 1.5 to 1.8 Nm (1.1
to 1.3 ft.- lb.).
FRONT VIEW
L2/N
L1/L
HEATER PAD
AC CONNECTIONS
LEFT SIDE VIEW
HEATER PAD WIRES
(TOP REAR)
SCREWS