User's Manual

A- 24
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
...........................................................................................................................................................................................................................................................
Install the heater pads on
each of the two battery
shelves
Perform the following steps install the heater pads on each of the two
battery shelves.
................................................................................................................................
............................................
1 Slide the heater pad onto the battery shelf while routing the cable and the
rear end of the heater pad down through the slot in the shelf and through
the slot at the back of the module. Refer to the figures below.
HEATER PAD
BATTERY
SHELF
SLOT IN
SHELF
S
LOT IN
M
ODULE
SIDE VIEW
BATTERY
SHELF