User's Manual

A- 25
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
............................................................................................................................................................................................................................................................
Important! When performing the next step, ensure that the
heater pad is correctly positioned inside the cavity of the cover so
that no "pinching" of the heater pad occurs.
................................................................................................................................
............................................
2 Place the metal cover over the heater pad and insert the two threaded
studs through the holes in the battery shelf. Refer to the figure below.
................................................................................................................................
............................................
3 Under the battery shelf, attach the cover plate with the nuts and washers
provided. When performing this step on the lower battery shelf of a
battery base module it is necessary to raise the inner frame somewhat to
gain access to the threaded studs.
................................................................................................................................
............................................
4 Repeat steps 1 through 3 for the second battery shelf
................................................................................................................................
............................................
5 At the rear of the inner battery frame, slide the heater pads rearward and
forward to ensure they are not pinched by the previously installed metal
heater pad cover. The heater pads must be all the way forward after
testing.
Important! When performing the next step, do not make sharp
bends in the heater pad.
HEATER
PAD
HEATER
PAD COVER
BATTERY
SHELF
ATTACH COVER WITH NUTS
ON THE THREADED STUDS
FROM UNDERNEATH
THREADED STUD
(1 of 2)