User's Manual

A- 26
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
...........................................................................................................................................................................................................................................................
................................................................................................................................
............................................
6 At the rear of the inner battery frame, curve the rear of the heater pads
as shown in the figure below, and. tape them to the rear of the module
with electrical tape:
• A: For a battery base module curve both heater pads upwards and
tape
• B: For an add-on battery module curve the bottom heater pad
downward into the module below and tape.
• C: For an add-on battery module curve the top heater pad upward
and tape.
................................................................................................................................
............................................
7 If installing a first or second battery base module continue the
installation on the next page.
If installing an add-on module with heater pads, skip to Install the battery
module outer frame over the inner frame and attach the internal ground cables
on Page A - 82 to continue the installation.
C
A
B
The bottom heater pad of an add-on
module must be curved downward (B).
Since access to the bolts for attaching
the add-on module outer frame to the
base module outer frame is through the
rear of the add-on module, curving the
pad upwards would block the access
opening