User's Manual

A- 30
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
...........................................................................................................................................................................................................................................................
Important! When performing the next step, take great care not
to damage the heater pads at the rear of the inner frame as it is
lowered into the outer frame.
................................................................................................................................
............................................
4 Place the battery base module inner frame into position inside the outer
frame and over the anchor holes. Observe the 1/4- inch clearance note.
Refer to the figure below.
................................................................................................................................
............................................
5 Remove the lifting eye bolts.
................................................................................................................................
............................................
6 Place the terminal lug of the internal ground cable from the inner frame
on the two threaded studs on the inside right side frame of the battery
module outer frame. Refer to the figure on Page A - 31.
................................................................................................................................
............................................
7 Using the nuts and washers provided, attach the ground cable to the
threaded studs. Torque according to the table in Chapter 1. Refer to the
figure on Page A - 31.
FRONT
O
UTER FRAME
INNER FRAME
Minimum 1/4-Inch
clearance required
between the inne
r
frame and the
12v bus bar
TOP VIEW
12v bus