User's Manual

7-16
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
...........................................................................................................................................................................................................................................................
Finishing the installation
Important! When connecting/disconnecting a Lucent RF
coaxial jumper cable assembly to/from any 7-16 DIN female
receptacle connector at the antenna, it is highly recommended that
the cable assembly be connected/disconnected as shown in the
figure above. Please note that the mating receptacle connector
requires a wrench for support to hold it in place. Wrenches for
connecting/disconnecting the mating RF coaxial jumper cable's 7-
16 DIN male plug, which is equipped with a rotating coupling nut,
are required.
................................................................................................................................
............................................
3 Torque the antenna jumper cable connections at the antenna connection
to 221 in.-lb. (25 Nm) using the method shown in the figure below.