User's Manual

A- 33
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
............................................................................................................................................................................................................................................................
................................................................................................................................
...............................................
3 Level the battery module using shims under the bottom plate. Refer to the
figure below.
................................................................................................................................
...............................................
4 Observe the minimum 1/4-inch clearance between the inner battery
frame and the 12v bus. Refer to the figure on Page A - 30.
................................................................................................................................
...............................................
5 Tighten the anchor bolts to 18 ft.-lb (24 Nm).
PLACE S
HIMS
AROUND
ANCHOR BOLTS
UNDER BOTTOM
PLATE
MODULAR
CELL
CABINET
or
FIRST
BATTERY
BASE
MODULE
BATTERY
BASE
MODULE
FRONT VIEW
TOP PANEL AND FILTER PANEL
FRONT PANEL
(IF APPLICABLE)