User's Manual

A- 34
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
...........................................................................................................................................................................................................................................................
Connect the battery base
module grounding cables
This procedure provides instructions for the installation of two # 2
AWG / 35-mm
2
battery base module grounding cables. The battery
base module requires two grounding cables that connect the base
module to the grounding system. The grounding cables are supplied as
part of site preparation. The crimp lugs, with installation hardware, are
supplied with the base module. Refer to the figure on Page A - 35.
Perform the following steps to connect the battery base module
grounding cables.
Important! This section describes the procedures for grounding
of the first and second EZBFo battery base modules. Instructions
for the subsequent internal grounding of stackable add-on battery
modules on top of the battery base module are provided later in
this appendix as part of the installation instructions. Batteries are
also installed later in this appendix.
................................................................................................................................
............................................
1 Prepare the grounding cables with sufficient length to reach from the
grounding system to the rear of the battery base module. Leave
approximately six inches of slack. Refer to the figure on Page A - 35.
................................................................................................................................
............................................
2 Strip the battery base module end of both cables.
................................................................................................................................
............................................
3 Remove the two double-hole terminal lugs from the shipping location
on the bottom rear of the battery base module. Refer to the figure on
Page A - 35.
................................................................................................................................
............................................
4 Crimp a double-hole terminal lug onto the battery base module end of
both cables.
................................................................................................................................
............................................
5 Verify that the battery base module grounding lug locations are free of
paint and polish if necessary.