User's Manual

A- 43
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
............................................................................................................................................................................................................................................................
Identify the individual cable
connectors and their
terminations on each end
Identify the individual cable connectors on the Modular Cell cabinet
end. Refer to the numbered list below and the figure on Page A - 44 for
cable and connector identification.
1. The fuse alarm cable (J309)
2. The battery module fan power/alarm cable (P2)
3. The intrusion alarm cable (SW1-COM and SW1-NC)
4. 4.0B Thermal probe cable
5. The AC heater cable 3-Pin
6. The DC cables (four +24V load / four 24V Return, without
terminal lugs) 2 AWG
Identify the individual cables/connectors on the first EZBFo battery
base module end. Refer to the numbered list below and the figure on
Page A - 44 for cable and connector identification.
7. The fuse alarm cable: Connectors SW2-1 and SW2-4
8. The intrusion alarm cable: Connectors "SW1-COM" and
"SW1- NC"
9. The fan power/alarm cable: Connector "J9" (the fan power/alarm
connector)
10. 4.0B Thermal probe cable with thermal probe
11. The AC heater cable (3 wire)
12. The DC cables (four +24V load / four 24V Return, with 2 hole
terminal lugs) 2 AWG