User's Manual

A- 46
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
...........................................................................................................................................................................................................................................................
................................................................................................................................
............................................
5 Individually tape the unterminated ends all eight of the DC cables inside
the Modular Cell 4.0B cabinet
MODULAR CELL
4.0B
CABINET
FIRST EZBFo
BATTERY BASE
MODULE
SW2-1 / SW2-4:
FUSE ALARM
"SW1-NC" AND
"SW1-COM":
INTRUSION ALARM
"J9": FAN
POWER/ALARM
CABLE CONDUIT
b.
T
HERMAL
PROBE
FOR
DETAIL:
Refer to the
figure on
Page A - 44
1
2
4
3
5
6
KEY
1.
T
he fuse alarm cable: Connectors SW2-1 and SW2-4
2.
T
he intrusion alarm cable: Connectors "SW1-COM" and "SW1-NC"
3.
T
he fan power/alarm cable: Connector "J9" (the fan power/alarm connector)
4. The thermal probe cable
a. Thermal probe cable
– One for first battery base module, when installed , to be moved to the second
battery base module, when installed
b. Thermal probe ; the thermal probe is shipped unconnected
– One for each connector on the thermal probe cable
5. The AC heater cable (
3 wire)
6. The DC cables (four +24V DC load/ four 24V Return / with terminal lugs)
a.
THERMAL PROBE
CONNECTION