User's Manual

A- 48
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
...........................................................................................................................................................................................................................................................
.............................................................................................................................................................................................................................................................
How to connect the AC cable from the Modular Cell cabinet
Overview
Description of the AC wiring installation for the heater pads in the
battery base module
The AC cable from the Modular Cell cabinet will be routed across the
bottom front of the battery base module and connected to the AC
terminal block that was previously installed as part of the AC heater kit.
Route and connect the AC
cable from the Modular Cell
cabinet to the AC block in
the battery base module
Perform the following steps to route and connect the AC cable in the
battery base module.
................................................................................................................................
............................................
1 Route the AC cable from the conduit on the left side of the battery base
module, across the bottom front of the module to the right side. Refer to
the figure below.
................................................................................................................................
............................................
2 Position the cable against the inside front edge of the outer frame.
................................................................................................................................
............................................
3 Dress the AC cable, and secure it to the inside front edge of the outer
frame with wire ties, in such a way that:
• It does not come into contact with DC cables
• It does not interfere with the subsequent installation of batteries
Route and connect the AC cable from the Modular Cell cabinet
to the AC block in the battery base module
A - 48
A
C CABLE