User's Manual

A- 49
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
............................................................................................................................................................................................................................................................
• It does not interfere with the reinstallation of the front panel
................................................................................................................................
............................................
4 Route the AC cable up to the top of the AC terminal block mounting
bracket and then down from the top as shown in the figure below.
................................................................................................................................
............................................
5 Wire tie the cable to the mounting bracket in the two locations shown in
the figure below.
................................................................................................................................
............................................
6 Route the AC cable to the bottom of the AC block and cut it to the
correct length, while leaving adequate slack. Refer to the figure on Page
A - 49
AC Terminal Block
A
C Cable from
the Modular
Cell Cabinet
W
ire tie AC
C
able to the
t
erminal
b
lock
b
racket at
t
hese two
p
oints