User's Manual

A- 56
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
...........................................................................................................................................................................................................................................................
Route the thermal probe
cable and mount the
thermal probe in the
battery base module
Perform the following steps to route the thermal probe cable and mount
the thermal probe in the battery base module.
................................................................................................................................
............................................
1 Locate the thermal probe cable from the Modular Cell cabinet. This
cable has a connector for connection of an internal thermal probe.
Attach the internal thermal probe to the connectors.
Important! Note that the internal thermal probe cable is made
long enough for other applications. Therefore, excess cable should
be properly dressed.
................................................................................................................................
............................................
2 Route the thermal probe cable from the outer frame into the inner frame
on the left side. Using the self-stick mounting bracket and wire tie,
attach the thermal probe in the location inside the frame shown in the
figure below.
Important!The thermal probe will be moved up to the top add-on
module as subsequently installed.
THE OUTER FRAME IS
SHOWN REMOVED FO
R
CLARITY
INNER
FRAME
Mount the
thermal probe
in this location
on the inside of
the frame