User's Manual

ManualsBrandsAlcatel-Lucent USA ManualsElectronicsUMTS-CDMA Transceiver System (850)

A- 1

Lucent Technologies – Proprietary

See notice on first page

401-703-454

FOA Draft Issue 1

January, 2006

............................................................................................................................................................................................................................................................

Appendix A: EZBFo battery frame

installation with Modular Cell 4.0B

cabinets (with integrated power)

Overview

Purpose

This appendix provides instructions for installing the Lucent

Technologies EZBFo battery modules with an outdoor Modular Cell

4.0B cabinet that has integrated power.

The procedures provided in this Appendix are for right side EZBFo

installation with 4.0B primary cabinets. When EZBFo frames are being

installed with a 4.0B dual band cabinet, the frames are installed on the

left side of the cabinet. The procedures are all the same except for the

routing direction of the cables. Cable routing inside of the dual band

cabinet is provided.

Contents

This appendix contains the following sections.

Introduction A - 2

How to perform placement, anchor, and prewire procedures for installation of the first or

second EZBFo battery base modules

A - 8

How to identify and route the cables from the Modular Cell cabinet to the first EZBFo

battery base module

A - 36

How to route and connect the cables in the first EZBFo battery base module

A - 47

How to

identify, route and connect the first EZBFo battery base module cables in the

Modular Cell 4.0B cabinet

A - 64

How to

install an EZBFo battery add-on module on an existing EZBFo battery module A - 76

How to install a second EZBFo battery base module A - 101

How to install the batteries in the EZBFo battery modules

A - 124

How to make final DC connections

A - 140