User's Manual

ManualsBrandsAlcatel-Lucent USA ManualsElectronicsRRH2X60-850

General site requirements

General requirements

The following general requirements must be met before the installation of the RRH can

begin:

• Adequate clearance must be provided for service access.

• Electric service must be installed as described in Appendix C “Electrical power

requirements”.

• Back haul and user alarm facilities must be installed as described in

Chapter 9, “User

alarm, and fiber optic requirements”

• Grounding electrode system must be installed.

• RF antenna runs must be installed (if required).

• Tower light power must be installed (if required).

• Tower light alarm must be installed (if required).

• Mounting bracket holes must be drilled.

• The environment must comply with limits listed in

“Environmental requirements”

(p. 5-2)

• Cable supports and racks must be installed.

Cable support and racks

All RF cable runs, power cable runs, and facilities cable runs must be supported by a

cable support and rack system.

The according cable conduits must be provided.

Structural requirements

Pole, wall loading, and wind must be considered during site preparation.

In some cases, cell site equipment may not be mounted directly to the wall without plate

or strut to properly distribute the load.

The support structure must be designed in compliance with national building codes and

all other applicable codes.

Site requirements General site requirements

....................................................................................................................................................................................................................................

Alcatel-Lucent RRH 2X60W

NN-20500-305 UA08.1

Issue 0.7 November 2011

Alcatel-Lucent – Proprietary

Use pursuant to applicable agreements

5-3

RELIMINARY