Operation Manual

Registering the telephone
7
32
Other
7.1
Subscribing the handset to a DECT system
You must subscribe the handset to at least one DECT system before you can use the handset to make a call.
When the handset is not yet subscribed to a system, the following message appears on the display screen:
Register.
Before you subscribe to a DECT system, obtain the following information from your system administrator:
• PARK code: Use a PARK code system ID only if more than one DECT system overlaps in your location.
• DECT system name: The name of the system to which you subscribe. After you enter the system name, it
appears on the idle display.
• Phone number: The local phone number assigned to your DECT handset.
When entering text, you can switch to the upper case mode, lower case and the numeric keypad by pressing
successively on the # key.
To subscribe your handset to a DECT system, perform the following steps.
The handset can operate with a maximum of four DECT systems.
Menu Access MENU
Select Access the handset settings menu
Select the tab: Connectivity
Register
Select
Place on cursor (highlight) : Register
Ok Enter the PIN Code (The default is 0000)
Select Select an empty slot or an existing system which will be replaced
If there are no more free slots, you have to replace an existing system to add a new one.
Park
Save
Use a PARK code system ID if more than one DECT system overlaps in your location.
If only one DECT system is available, make no entry, and press the Skip soft key.
OR
Skip If only one system is available
PIN code:
Ok
Enter the PIN Code (The default is 0000)
Network
name
Save
Enter the system name
Save Enter the phone number assigned to your handset
OXE/OXO Select the system
Once recording is complete, the set automatically switches to idle mode. Once recording
is complete, the set automatically switches to idle mode.