Alcatel-Lucent 8340 Smart IP-DECT AP Installation Manual 8AL90850USBAed01 -10/2013
Alcatel-Lucent 8340 Smart IP-DECT AP Installation Manual Alcatel, Lucent, Alcatel-Lucent and the Alcatel-Lucent logo are trademarks of AlcatelLucent. All other trademarks are the property of their respective owners. The information presented is subject to change without notice. Alcatel-Lucent assumes no responsibility for inaccuracies contained herein. Copyright© 2013 Alcatel-Lucent. All rights reserved.
Alcatel-Lucent 8340 Smart IP-DECT AP Installation Manual Regulatory information European Union Declaration of Conformity This equipment is in compliance with the essential requirements of R&TTE Directive 1999/5/EC.The Declaration of Conformity may be obtained from your installer.
Alcatel-Lucent 8340 Smart IP-DECT AP Installation Manual must accept any interference received, including interference that may cause undesired operation. Modifications not expressly approved by the manufacturer could void the user’s authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Alcatel-Lucent 8340 Smart IP-DECT AP Installation Manual Regulatory information Canada This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
Alcatel-Lucent 8340 Smart IP-DECT AP Installation Manual 8AL90850USBAed01 5
Alcatel-Lucent 8340 Smart IP-DECT AP Installation Manual Contents: 1 8340 SMART IP-DECT AP GENERAL ......................................................................... 9 1.1 GENERAL ........................................................................................................... 9 1.2 COUNTRY SELECTION ..................................................................................... 9 1.3 SITE REQUIREMENTS.............................................................................
Alcatel-Lucent 8340 Smart IP-DECT AP Installation Manual PREFACE This manual is applicable for the 8340 SMART IP-DECT AP, DECT Transceiver. Please note that some product models or features described in this manual may not be available in all world regions.” No legal rights can be obtained from information in this manual.
Alcatel-Lucent 8340 Smart IP-DECT AP Installation Manual 8AL90850USBAed01 8
Alcatel-Lucent 8340 Smart IP-DECT AP Installation Manual 1 8340 SMART IP-DECT AP GENERAL 1.1 GENERAL This installation Manual is valid for installing a DECT transceiver (8340 Smart IP-DECT AP) to a wall in horizontal or vertical position. The 8340 Smart IP-DECT AP is designed for indoor use.
Alcatel-Lucent 8340 Smart IP-DECT AP Installation Manual Note: In North America, only the “DAP Controller - North America” will be delivered, so no other frequencies than the North America frequencies and power levels are possible in North America. Note: In Europe, only the “DAP Controller - International” will be delivered, so no other frequencies than the European frequencies and power levels are possible in Europe.
Alcatel-Lucent 8340 Smart IP-DECT AP Installation Manual 1.5 CABLE SPECIFICATIONS FOR 8340 Smart IP-DECT AP Types The cabling to the 8340 Smart IP-DECT AP External antennas should be “Category 5” or “Category 6” Ethernet cabling. The interface is defined as an SELV interface according EN60950-1. For this reason the safety restriction as given in the next chapter should be respected: The power for the 8340 Smart IP-DECT AP External antennas must be supplied via the Ethernet cable, PoE (IEEE 802.3af).
Alcatel-Lucent 8340 Smart IP-DECT AP Installation Manual 1.7 INTERNAL ELECTRICAL ISOLATION The 8340 Smart IP-DECT AP external antennas provides internal isolation (1,5 kV) between the Ethernet connection and the internal electrical components, including the antenna’s and antenna connector in the 8340 Smart IP-DECT AP external antennas in the 8340 Smart IP-DECT AP. 1.8 G.729 DAUGHTER BOARD By default the G.729 Daughter Board is installed on the 8340 Smart IP-DECT AP.
Alcatel-Lucent 8340 Smart IP-DECT AP Installation Manual When the 8340 Smart IP-DECT AP is mounted horizontally, the antenna position must be changed (see chapter 2). Figure 2. 8340 Smar IP-DECT AP mounted horizontally 1.11 INSTALLATION PROCEDURES The installation of an Outdoor Cabinet comprises the installation of: Adjusting the Antenna position (if necessary). Mounting the G.729 Daughter Board (if applicable) Mounting the 8340 Smart IP-DECT AP against the wall.
Alcatel-Lucent 8340 Smart IP-DECT AP Installation Manual 1.12 UNPACKING PROCEDURE: “Unpacking”. Actions 1. Open the card board box and take the 8340 Smart IP-DECT AP out. 2. Check the 8340 Smart IP-DECT AP for any damage. 3. Continue with one of the following Chapters: When you mount the 8340 Smart IP-DECT AP vertically, the antenna position will normally be OK, and when you do not need to install the G.
Alcatel-Lucent 8340 Smart IP-DECT AP Installation Manual 2 ADJUSTING THE ANTENNA POSITION This chapter is not applicable for the 8340 Smart IP-DECT AP External antennas. Note: You only need to change the antenna position when you mount the 8340 Smart IP-DECT AP horizontally! In all other cases you don’t need to change the antenna position. Figure 3. 8340 Smart IP-DECT AP mounted horizontally PROCEDURE: “Adjusting the Antenna position”. Note: Antenna position can be changed once.
Alcatel-Lucent 8340 Smart IP-DECT AP Installation Manual Screws are inside these holes Figure 4. Rear side of Cabinet. 2. Open the cabinet CAREFULLY! Make sure that you shift the cover of the antenna’s carefully from the antenna’s. 3. Take the antenna cover from the 8340 Smart IP-DECT AP cover. 4. To put the antennas in vertical position, bend them carefully as shown in Figure 5. Bend Antennas carefully into vertical position.
Alcatel-Lucent 8340 Smart IP-DECT AP Installation Manual Figure 5. Bend Antennas carefully into vertical position. 5. After the antennas are put in the vertical position, close the 8340 Smart IP-DECT AP cabinet again. In other words, put the 8340 Smart IP-DECT AP cover back into position and secure the screws at the rear side of the cabinet. See Figure 6. Antennas locked into Cover. Figure 6. Antennas locked into Cover.
Alcatel-Lucent 8340 Smart IP-DECT AP Installation Manual 6. Make sure that the antennas are properly locked into the locks in the 8340 Smart IPDECT AP cover. Figure 7. Detail of Antenna in lock. 7. Move the antenna cover carefully over the antennas in the vertical position and make sure that the antennas do not bend. When the antenna cover is in its position, push it further into its position in the 8340 Smart IP-DECT AP cabinet to fix it. Figure 8. Cover installed. 8.
Alcatel-Lucent 8340 Smart IP-DECT AP Installation Manual 3 MOUNTING THE G.729 DAUGHTERBOARD Follow the step-by-step procedure below, to install the G.729 daughter board. PROCEDURE: “Installing the G.729 Daughter Board”. Actions 1. Make sure that you have the G.729 Daughter board. 2. Open the cabinet. Use steps 1 and 2 in Chapter 2. 3. Take the PCB out of the cabinet. Note: Mind the light conductor for the LEDs. It can drop off! LED Light conductor Figure 9. Light conductor for LEDs 4.
Alcatel-Lucent 8340 Smart IP-DECT AP Installation Manual Sticky foam Figure 10. G.729 Daughter Board with sticky foam 6. Mount the G.729 Daughter Board onto the main PWB. Push the Daughter Board carefully onto the main board. The white connector should fit well. Make sure that the sticky part sticks to the Main Board. Figure 11. Mounting the G.729 Daughter Board onto the Main board. 7.
Alcatel-Lucent 8340 Smart IP-DECT AP Installation Manual 4 MOUNTING THE 8340 Smart IP-DECT AP AGAINST A WALL/CEILING PROCEDURE: “Procedureformountingthe8340 Smart IP-DECT AP to the wall”. Actions 1. Remove the mounting plate from the 8340 Smart IP-DECT AP cabinet. Push clip up, to take mounting plate off. Figure 12. How to take the mounting plate off.
Alcatel-Lucent 8340 Smart IP-DECT AP Installation Manual 2. Mount the mounting plate to the wall or ceiling, using appropriate fitings. Figure 13. Mounting plate.. 3. Make sure that the Ethernet cable to the cabinet has the correct length. 4. If necessary, mount the RJ45 connector to the cable using the tool for mounting an RJ45 connector plug to a Category 5 or Category 6 cable. 5. Lead the cable to the 8340 Smart IP-DECT AP cabinet and connect the RJ45 connector. Push the cable into the groove.
Alcatel-Lucent 8340 Smart IP-DECT AP Installation Manual 6. Push the cabinet onto the mounting plate. Note: When pushing the 8340 Smart IP-DECT AP on to the mounting plate, make sure that you hear/feel a distinct click. This indicates that the 8340 Smart IP-DECT AP is firmly mounted to the mounting plate. Figure 15. 8340 Smart IP-DECT AP mounted against the wall.
Alcatel-Lucent 8340 Smart IP-DECT AP Installation Manual 5 LEDs 5.1 LED Status The 8340 Smart IP-DECT AP is equipped with two LEDs. Top LED – Yellow This LED represents the status of the 8340 Smart IP-DECT AP.
Alcatel-Lucent 8340 Smart IP-DECT AP Installation Manual Lower LED – Red/Green This LED is used to indicate the start-up and network status. LED Status (lower LED, Red/Green) Meaning RED Steady on Power but FPGA starting up RED flashing Trying to connect to the network Green flashing Network status display and showing network activity Off 8340 Smart IP-DECT AP operational Table 2. Lower LED status on the 8340 Smart IP-DECT AP. 5.
Alcatel-Lucent 8340 Smart IP-DECT AP Installation Manual A SPECIFICATIONS Dimensions / Environment: Dimensions (W x D x H) ............................... : Outside temperature range........................... : IP Specification ........................................... : Relative Humidity ......................................... : 145 x 43 x 174 -5 C . . . 45 C The 8340 Smart IP-DECT AP should not be exposed to sunlight. . When in Outdoor Box = IP66 5 . . .
Alcatel-Lucent 8340 Smart IP-DECT AP Installation Manual Note: Country selection is determined by the DAP Controller Type! See section 1.2 COUNTRY SELECTION.
