User Guide

OmniAccess 3500 Nonstop Laptop Guardian Gateway Installation Guide
o Read Community: This string is used for SNMP authentication and is similar to
a password used by the SNMP clients to access information. If an SNMP Client
uses a Read Community, it is allowed read-only access to the Information. It is
recommended that the Read Community and Read-Write Community strings are
different.
o Confirm Read Community: Re-type the Read Community string in this field.
o Read-Write Community: This string is used for SNMP authentication and is
similar to a password used by the SNMP clients to access information. If an
SNMP client uses a Read-Write Community, it is allowed to read information as
well as modify it. It is recommended that the Read Community and Read-Write
Community strings are different.
o Confirm Read-Write Community: Re-type the Read-Write Community string in
this field.
HTTPS Settings
o HTTPS Port: The port on which you can securely access the management
system GUI from a web browser. The default value is <443>, in which case you
don't have to specify the port in the URL. If you set a different port, you will
have to indicate the port number in the URL while accessing the management
system. For example, if you specify the HTTPS port as <8443>, and the address
of the LAN interface (accessible from within the enterprise network) is
<10.1.1.1>, then you can open the management system GUI by typing the
following URL in the address box of your browser: <https://10.1.1.1:8443>.
IPsec Configuration
o Card Address Range: IP address pool for assignment to the OmniAccess 3500
NLG cards when they connect to the gateway. This entry must be filled with
one address range when the gateway is first configured. Later on, the editing
of the initial card address range or the introduction of new address ranges must
be applied on the [Gateway Configure-> Address Pool Information] window,
reachable through the [Gateway|Configure Advanced Settings|Address Pool]
path.
o Card Address Mask: Network mask for identification of the card address pool
set upon initial configuration of the gateway.
o Laptop Address Range: IP address pool for assignment to the laptop when the
corresponding Card connects to the gateway. This entry must be filled with one
address range when the gateway is first configured. Later on, the editing of the
initial card address range or the introduction of new address ranges must be
applied on the [Gateway Configure-> Address Pool Information] window,
reachable through the [Gateway|Configure Advanced Settings|Address Pool]
path.
o Laptop Address Mask: Network mask for identification of the laptop address
pool set upon initial configuration of the gateway.
o Gateway Certificate ID Type: Type of digital certificate used by the
OmniAccess 3500 NLG gateway for mutual authentication with the OmniAccess
3500 NLG cards. This entry must be set when the gateway is first configured.
Later on, any modification of the Gateway Certificate ID Type must be applied
36