User Guide

Chapter 3. Runtime Administration Functions
To display the properties of a volume that was previously released by the
administrator:
1. Click Users on the main menu.
2. Click the checkbox next to a user to select it and then click Configure.
3. On the User Configurations window, click Deleted Volume Properties under the
TrueCrypt Volume Encryption menu.
4. The Deleted Volume Information window appears (Figure 49), displaying all data
needed for reconfiguration of the same volume in the laptop’s hard disk.
Note: The restoration of a relinquished encrypted volume cannot be performed
remotely by the administrator through the management system. Instead, the end
user must enter the necessary parameters locally, through the user interface that
comes with the encrypted volume software.
5. Click OK.
Only the end user can physically remove the encrypted volume from the laptop hard
disk, by deleting the file corresponding to the volume path after the administrator has
relinquished administrative control over it.
Figure 49 - Deleted Volume Information
To change the secret password stored in the OmniAccess 3500 NLG card:
1. Click Users on the main menu.
2. Click the checkbox next to a user to select it and then click Configure.
3. On the User Configurations window, click Volume Settings under the TrueCrypt
Volume Encryption menu.
4. If the check box next to Volume Enable is currently checked, click it to uncheck it
and click Save.
63