User Guide

Chapter 5. Administrative Information Base
address range when the gateway is first configured. Later on, the editing of the
initial card address range or the introduction of new address ranges must be
executed on the [Gateway Configure-> Address Pool Information] window,
reachable through the [Gateway|Configure Advanced Settings|Address Pool]
path.
o Laptop Address Mask — Network mask for identification of the laptop address
pool set upon initial configuration of the gateway.
o Gateway Certificate ID Type — Type of identifier for the digital certificate
that is used by the OmniAccess 3500 NLG gateway for mutual authentication
with the OmniAccess 3500 NLG cards. Options available (choose one): <EMAIL>,
<FQDN>, <DN>. This entry must be set when the gateway is first configured.
Later on, the setting of the Gateway Certificate ID Type (possibly with a
different value than the initial one) must be executed on the [Connection
Manager Tunnel Table (Add)] window, reachable through the
[Gateway|Configure Advanced Settings|Tunnel Table|New] path.
o Gateway Certificate ID — Identifier of the certificate that the OmniAccess
3500 NLG gateway uses for mutual authentication with the OmniAccess 3500
NLG cards. This entry must be set when the gateway is first configured. Later
on, the setting of the Gateway Certificate ID (possibly with a different value
than the initial one) must be executed on the [Connection Manager Tunnel
Table (Add)] window, reachable through the [Gateway|Configure Advanced
Settings|Tunnel Table|New] path. Please note that this parameter is case-
sensitive.
Figure 63 - Gateway Configurations (Edit)
83