User Guide

ManualsBrandsAlcatel-Lucent ManualsSwitchOmniAccess 6000

Alcatel OmniAccess 6000 Supervisor Card Installation Instructions 1

Alcatel OmniAccess 6000 Supervisor Card

Installation Instructions

These installation instructions describe the steps needed to insert

and remove the Alcatel 6000 Wireless LAN switch supervisor

module (OAW-SC-1). The supervisor cards are hot

swappable

. Hot swapping allows the supervisor card to be

replaced without shutting down the Alcatel Wireless LAN Switch.

Physical Description

The Supervisor Card

Module Fastening Screws

Module Handle

This handle is used for removing or inserting the module into the

switch chassis.

1.Hot swapping a supervisor card on a live Alcatel 6000 WLAN switch is service

affecting and all traffic processing will stop until a replacement supervisor card

is installed, configured, and operating.

ACTIVE/

STANDBY

PCMCIA SERIAL ETHERNET

LNK/

ACT

UTILIZATION

1% 100%

RESET

POWER

STATUS

3 4 5 6 7 8

CAUTION—Do not use the Supervisor Card Module handle for lifting or

moving the Alcatel Wireless LAN Switch. Serious damage could result.

Summary of content (6 pages)

PAGE 1
Alcatel OmniAccess 6000 Supervisor Card Installation Instructions These installation instructions describe the steps needed to insert and remove the Alcatel 6000 Wireless LAN switch supervisor module (OAW-SC-1). The supervisor cards are hot swappable1. Hot swapping allows the supervisor card to be replaced without shutting down the Alcatel Wireless LAN Switch.
PAGE 2
OmniAccess 6000 SC Installation Notes: Installation Guide 3 Indicator LEDs TABLE 1 LED Description LED State Description Power Green Module is receiving proper DC power. Off Module is powered off. Green Module has booted and is functioning properly. Off Module is loading software. Amber Module has loaded software and is initializing. Red Module has failed. Status Active/Standby Green Module is in active mode. Amber Module is in standby mode.
PAGE 3
Inserting a Supervisor Card CAUTION—This procedure should be performed only by a trained technician. CAUTION—Be sure to exercise proper Electrostatic Discharge (ESD) precautions when handling Alcatel 6000 5000 components. The supervisor card is hot-swappable and can be inserted into the Alcatel Wireless LAN Switch chassis while system power is on or off. 1 Make sure you understand the procedure and all precautions. Before beginning, read the entire procedure.
PAGE 4
OmniAccess 6000 SC Installation Notes: Installation Guide 5 Secure the supervisor card. Use a #2 Phillips or cross-head screwdriver to push in the captive fastening screws and turn them clockwise until moderate resistance is felt. Do not over-tighten. 6 Connect the appropriate network cables. Removing a Supervisor Card CAUTION—This procedure should be performed only by a trained technician.
PAGE 5
Port & Cable Specifications Serial Port The serial port is located on the front panel of the supervisor card. The port’s RJ-45 female connector accepts an RS-232 serial cable a male connector.
PAGE 6
OmniAccess 6000 SC Installation Notes: Installation Guide FE Port The FE port provides a 10/100 Mbps Ethernet connection to a network. The RJ-45 female connector port pin-outs are shown in Figure 2: 10/100 Mbps Ethernet RJ-45 Female Pin-Out 1 2 3 4 5 6 7 8 ETH Tx+ ETH Tx– ETH Rx+ ETH Rx– Direction Receive Transmit FIGURE 2 FE Port The port accepts a 4- or 8-conductor Category 5 (or better) UTP Ethernet cable with an RJ-45 male connector.