User Guide

ManualsBrandsAlcatel-Lucent ManualsSwitchOmniAccess 6000

Alcatel 6000 Fan Tray Assembly Installation Instructions 1

Alcatel OmniAccess 6000 Fan Tray

Assembly Installation Instructions

This guide describes the general features and physical

characteristics of the Alcatel 6000 series Wireless LAN Switch fan

tray assemblies (OAW-6000-FT), and provides instructions for

replacing the module.

The fan tray slot is located on the left side of the Aruba WLAN

Switch chassis and extends from the front of the chassis to the

back.

Module Fastening Screws

FAN

STATUS

SLOT

Summary of content (6 pages)

PAGE 1
Alcatel OmniAccess 6000 Fan Tray Assembly Installation Instructions This guide describes the general features and physical characteristics of the Alcatel 6000 series Wireless LAN Switch fan tray assemblies (OAW-6000-FT), and provides instructions for replacing the module. The fan tray slot is located on the left side of the Aruba WLAN Switch chassis and extends from the front of the chassis to the back.
PAGE 2
OmniAccess 6000 200W PSU Installation Notes: Installation Guide These captive screws are used for securing the module into the switch fan tray slot. 2 Module Handle This handle is used for removing or inserting the module into the switch chassis. CAUTION—Do not use the fan tray handle to lift or move the Aruba WLAN Switch. Serious damage could result.
PAGE 3
Replacing a Fan Tray CAUTION—This procedure should be performed only by a trained technician. CAUTION—Be sure to exercise proper Electrostatic Discharge (ESD) precautions when handling components. If hot-swapping the fan tray, please be aware that there are time-critical aspects to parts of the procedure. To ensure proper preparation, please read through all the steps in the procedure before attempting the replacement. Also, make sure you understand all the precautions in this guide.
PAGE 4
OmniAccess 6000 200W PSU Installation Notes: Installation Guide 3. Disengage the fan tray. Grasp the module handle firmly and draw the fan tray forward from its slot. There may be moderate resistance as the module comes free from its connections with the chassis backplane, but do not use excessive force. When the module is fully disengaged from the backplane, power to the working fans is lost and they will gradually stop spinning .
PAGE 5
4. Check the fans to make sure all of them are working. Once power has been restored to the fan tray, either by engaging the module to the backplane during hot-swap or by turning on system power after a cold-swap, the Fan Status LED should be green and you should be able to feel significant airflow blowing from the chassis vents at each fan position. If the fans are all working, this ends the time critical portion of the hot-swap procedure.
PAGE 6
OmniAccess 6000 200W PSU Installation Notes: Installation Guide 6 Part 031656-00 May 2005