User's Manual

4-4

Screen shown is for DS1 Radio. DS3 and OC3 radio conﬁguration pro-

visioning is similar. Changes to provisioning do not have to be made in

any particular order.

Figure 4-2 DS1/E1, DS3, OC3 Radio Conﬁguration Provisioning (Sheet 2 of 4)

Note

ATPC Enabled A&B PA Present

RADIO CONFIG:

HS Tx/HS Rx TERMINAL

6-8 GHz

SYSTEM ALARM

Visual/Audible RELAYS ON/NO Station Alarm 13-16 RSL Alarm Enable

Disable AGC BER Disable

RCV SWITCHING:

RADIO TYPE:

MDR-8000 DS1 16 LINES 128 TCM

OPTIONS:

Stat/Prov/WaySideOption Key:

SYSTEM ID:

TEST1

Disable

RADIO LINK ID:ELMC:

LMW-7085

Sheet 2 of 2

06/04/02

SELECT ATPC OR ATPC T/O ENABLE AUTOMATIC XMT POWER CONTROL (ATPC) FUNCTION. WHEN PROVISIONED

ATPC OR ATPC T/0, ONE RCVR OUT-OF-LOCK CAUSES HIGH POWER ATPC FOR 10 SECONDS EVERY ONE MINUTE.

IF BOTH RCVRS ARE OUT-OF-LOCK, ATPC GOES TO HIGH POWER AND STAYS AT HIGH POWER UNTIL ONE RCVR

(REVERTS TO ONE RCVR OUT-OF-LOCK MODE) OR BOTH RCVRS LOCK. WHEN PROVISIONED ATPC T/O (TIMEOUT),

IF CMD PATH IS LOST, ATPC GOES TO HIGH POWER FOR FIVE MINUTES THEN GOES TO LOW POWER. THEN, EVERY

HOUR, ATPC GOES HIGH FOR 10 SECONDS AND THEN GOES TO LOW POWER. THIS CONTINUES UNTIL THE CMD

PATH IS RESTORED. SELECT DISABLE TO DISABLE ATPC FUNCTION.

NOTES

1. ATPC T/O IS A CMD PATH FUNCTION PERFORMED AT XMTR.

2. ATPC TRACKS RCVR WITH HIGHEST LEVEL.

3. LOW POWER ATPC IS 10dB DOWN FROM HIGH POWER.

SELECT RSL Alarm Enable TO ENABLE ALARM ON USI

ALARM AND STATUS SCREEN WHEN RSL DROPS

BELOW THRESHOLD. SELECT RSL Alarm Disable TO

INHIBIT ALARM.