User's Manual

3-29

MCS-11 must be provisioned

MCS-11 J310 Master/Junction

to enable

XMT, RCV, and OUTPUT clocks. If an external modem is being used,

provision MCS-11 for

MCS-11 J310 Modem

. This selection disables

XMT, RCV, and OUTPUT clocks and all MCS-11 clocks must now be

provided by the external modem.

MCS-11 J310 Master/Junction

must be selected unless an external modem is con-

nected to the radio. If an external modem is used it must provide all MCS-11 clocks and

the radio must be provisioned

MCS-11 J310 Modem

When provisioned

J308 Input Clock

, J308 and J309 RCV CLK and

XMT CLK and J308 OUTPUT CLK are disabled. Select

J308 Output

Clock

to send a 64 kb/s clock to external equipment (OUTPUT CLK

J308-4/12) and also enable RCV CLK and XMT CLK.

MCS-11 J308 Output Clock

must be selected unless an external clock source is pro-

vided that will supply all MCS-11 clocks. If an external clock source is used, the radio

must be provisioned

MCS-11 J308 Input Clock

3.15.5.1

MCS-11 (J307)

If the radio is provisioned

Repeater

, port 2 on the controller, that con-

nects to J307, is disabled. At a repeater, you can use J310 in lieu of

J307 for connecting the TSM polling engine to the radio.

MCS-11 connector J307 is used to connect to a TSM (-2500, -3500, or -8000) polling engine

at a master terminal.

Recommended connectorized cable assembly – PN 695-4126-007/009/012 (26 AWG 8 pair

shielded, jacketed cable). See Figure 3-20 for shelf connector location and pinout. Refer to

Table 3-8 for mating cable pinout and color code. See Figure 3-21 for typical connection

scheme.

Note