User's Manual

4-37
Figure 4 - 21 Audio 2 Provisioning
AUDIO 1:
AUDIO 2:
RS-232
MCS
TMN
Channel
3
MCS Transport
RF/Rptr
PPP Transport
RF/Rptr
Channel E-Lead
Off -GND
Level M-Lead
0/0 Norm
Address
A12A
J308/J309 Input Clocks
RSS
J310 Modem J308/J309 TerminationRDS/RAS/RCD
Channel 1 Channel 2 Repeater D/1
Channel E-Lead All Call Detect
Off -GND
DTMF
Level M-Lead 2-Wire Auto Squelch
0/0 Norm 00
Address
Radio Configuration Service Channel
WaySide DS1 Facilities
DS3 Facilities
Alcatel User Interface – [System, DS3, and DS1 Provisioning -- MDR-8000 DS3]
File View Setup Options
F6
Performance
Alarm Status
F4
Analog Monitor Station Alarm
F7
Provisioning
F9
User Control
F8F5
Prov. Save
F3
Thursday, March 7, 2000 1:27:15 PM USI Version R1.03 Controller Version R1.03 MDR-8000 3-DS3
ELMC Address:
ELMC Description:
J7914
DURANGO
LOCAL DS3 PROVISIONING
Communicating***
MDR-1036A
09/06/04
0/0 – RADIO REQUIRES 0 dBm AUDIO INPUT SIGNAL AT CONNECTOR J317.
THE RECEIVED AUDIO SIGNALS ARE NOT AMPLIFIED. THE RADIO
OUTPUTS 0 dBm ON AUDIO 2 CONNECTOR J317. THIS SELECTION IS
NORMALLY SUFFICIENT IF THE RADIO AND EXTERNAL AUDIO EQUIPMENT
ARE LOCATED IN THE SAME SHELTER, ROOM AND EVEN BUILDING.
LONGER DISTANCES (SUCH AS BETWEEN BUILDINGS) MAY REQUIRE
AMPLIFICATION ON THE OUTPUT SIGNAL. IN THIS CASE, SELECT -16/+7
WHERE THE RADIO INPUT REQUIRED IS -16 dBm AND THE RADIO
AMPLIFIES RECEIVED AUDIO SIGNALS TO PROVIDE A +7 dBm OUTPUT AT
AUDIO 2 CONNECTOR J317.
1:, 2: OR 3: – THE 64 kb/s SERVICE CHANNEL TO BE INSERTED INTO RADIO
OVERHEAD IS 1, 2, or 3. IF SERVICE CHANNEL 1 IS ALREADY IN USE, SELECT
SERVICE
CHANNEL 2 (2:) OR SERVICE CHANNEL 3 (3:) FOR THE AUDIO CHANNEL.
WHATEVER IS SELECTED FOR SERVICE CHANNEL 1, 2, OR 3, IT MUST BE THE
SAME END-TO-END.
SELECT E-Lead-24Vdc OR E-Lead GND TO
BE APPLIED TO SERVICE CHANNEL E-LEAD.
NORM – MODE OF OPERATION SELECTED IS NORMAL. IN THIS MODE
THE RADIO REQUIRES AN OFF HOOK SIGNAL FROM THE EXTERNAL
AUDIO EQUIPMENT. THIS MEANS THAT THE AUDIO EQUIPMENT USED
TO CONNECT TO THE RADIO MUST HAVE E AND M-LEAD SIGNALING
CAPABILITY (MOST AUDIO EQUIPMENT DOES HAVE THIS CAPABILITY).
IF THE EXTERNAL AUDIO EQUIPMENT DOES NOT HAVE E AND
M-LEAD SIGNALING CAPABILITY, SELECT O/H AND A CONSTANT
OFF-HOOK SIGNAL WILL BE PROVIDED AUTOMATICALLY BY THE
RADIO CONTROLLER SOFTWARE.