User's Manual
Table Of Contents
Radio
9500 MPR Product Information 347
For the management of mono-directional radio links, different configurations are needed
on each side of the link.
On the node where the link works in Tx only:
• ATPC, ACM should not be enabled: they cannot work
• LAG L1, Ring should not be created: they cannot work
• Radio PM should not be enabled: they work Rx side
• Link Identifier should not be enabled: it works Rx side
• PPP must be disabled (otherwise a PPP Failure alarm will be raised)
• For monodirectional links with the MPT-HLS, the space diversity combiner should
not be equipped on the transmitter side.
• For monodirectional links with the MPT-HLS, the RF switch should be mounted and
connected.
• “No Rx Radio Alarms” alarm profile must be configured in the radio panel (otherwise
all the Rx Radio alarms will be raised)
On the node where the link works in Rx only:
• Transmitter must be muted with a TX Mute command
• ATPC, ACM should not be enabled: they cannot work
• LAG L1, Ring should not be created: they cannot work
• PPP must be disabled (otherwise a PPP Failure alarm will be raised)
• For monodirectional links with the MPT-HLS, the space diversity combiner should
be equipped only on the receiver side.
• For monodirectional links with the MPT-HLS, the RF switch should be mounted and
connected.
• “No Tx Radio Alarms” alarm profile must be configured in the radio panel (otherwise
all the Tx Radio alarms will be raised)
8.2.28 — Unlicensed radio for MPT-HL, MPT-HLC and 9558HC in
the ANSI market
The JF6-9558H/6933B-9500MPT (MPT-HL) unlicensed radio provide fast deployment of
service with microwave radio. No license and small antennas (no FCC and Industry Canada
(IC) requirements) allow immediate Turn-Up. After the license is received, the unlicensed
MPT-HL radio can be easily converted to the lower 6 GHz licensed band.
DRAFT