User's Manual

document, use and communication of its contents
not permitted without written authorization from ALCATEL
All rights reserved. Passing on and copying of this
Issue 02 -January, 10 2000 29/1363CC10875AAAA TQ BJA 02
3.3 – Installing the equipment
3.3.1 – Information required for installation
Appendix 1 contains a sheet for you to complete to collate all the general information needed for the installation
procedure.
3.3.2 – Precautions
Installation is designed to meet all requirements concerning electromagnetic compatibility and safety.
The performance of the equipment decreases if the installation practices (cable installation, ground
connections, etc.)are not respected: installation should be based on best trade practices.
3.3.3 – Tools required
The installation personnel must possess a standard installation toolkit (containing, in particular: drill, drill bits,
soldering iron, cable tie pliers, terminal pliers).
The list of tools required for the mechanical installation of the equipment is given below:
Tool Use
No. 6 Allen key (for 8 mm screw) Antenna alignment
16/17 mm box wrench and flat
wrench
Used for pole mounting and for fine adjustment of the antenna and
various tightening operations
Torque wrench Used for pole mounting and various tightening operations
20 mm flat wrench For attaching the “N” coaxial connectors
A compass and an inclinometer (not supplied) are essential for pointing the antenna.
Depending on the installations, additional equipment may prove useful:
– Compax “ Mars Actel “OSA3 insertion and extraction tool, for terminal strip wiring
(mars actel cad) COMPAX;
– Crimping tool for the sub–D connectors, ref.:608868–1 (AMP) .