User's Manual

document, use and communication of its contents
not permitted without written authorization from ALCATEL
All rights reserved. Passing on and copying of this
8/136 3CC10875AAAA TQ BJA 02
Issue 02 -January, 10 2000
1.3 – Safety instructions
1.3.1 – General rules
The following general safety precautions must be observed by the installer and the operator. ALCATEL
assumes no liability for the customer’s failure to comply with these requirements.
Ground the equipment:
For Safety Class 1 equipment, always connect the earth conductor of the power cable to an appropriate earthing
device.
DO NOT operate the product in an explosive atmosphere or in presence of flammable gases or fumes.
For protection against fire:
replace the line fuse(s) only with fuse(s) of the same voltage and current rating and type.
Dangerous voltages:
Users must not remove equipment covers or shields. The installation and maintenance procedures described
in this manual are for use by service–trained personnel only.
DO NOT operate equipment which may be damaged:
Whenever it is possible that the safety protection features built into this equipment have been impaired,
ISOLATE FROM THE POWER SUPPLY and do not use the equipment until safe operation can be verified by
service–trained personnel. If necessary, return the equipment to Alcatel After Sales for service and repair.
DO NOT substitute parts or modify equipment:
Return the product to Alcatel Customer Service for servicing and repair.
1.3.2 – Symbols on products
1.3.2.1 – Danger symbols
When subsystems and modules have warning labels, it is extremely important to follow their instructions.
These labels are designed to indicate dangerous situations; they may contain any standard symbol or any text
considered necessary to protect users and employees.
The most frequent danger situations and symbols are:
Danger or general warning
Prompts the user to refer to the manual.
Dangerous electrical voltages
Close to dangerous voltages (>42.4 V AC peak, 60 V DC; power level >240 VA) you will find
this warning label
Presence of heat-radiating mechanical parts