User guide

GNI Modules Network Interface (NI) Modules

page 5-18 OmniSwitch 7700/7800 Hardware Users Guide April 2005

Removing MiniGBIC Connectors

MiniGBICs modules can be hot swapped. You are not required to power off the switch before removing a

MiniGBIC from an OS7-GNI-U12 module. To remove a Miniature Gigabit Interface Converters (Mini-

GBIC) follow the steps below.

Note. Before handling any components, free yourself of static by wearing a grounding strap, or by ground-

ing yourself properly. Static discharge can damage the MiniGBIC, as well as the Gigabit Ethernet fiber

module. Refer to “Using the Grounding Wrist Strap and Chassis Grounding Lug” on page 5-24 for more

information.

1 Remove any LC cables from the MiniGBIC.

2 To remove a MiniGBIC you must first open the MiniGBIC’s hinged face to approximately ninety

degrees. Then, grasp the hinged face and carefully pull the MiniGBIC straight out of the slot.

3 Slide the MiniGBIC out of the OS7-GNI-U12’s port.

4 Store the MiniGBIC in a secure, static-free location. Placing the MiniGBIC in an anti-static bag is

recommended.

LINK