How-To Guide

EN - 5
FAQ
Q1: How can I remove a node from my WiFi network?
A1: Tap the node on the TCL WiFi App, tap .... in the upper-right
corner, and choose Delete.
Note: Removing operaon restores the node to factory sengs.
Q2: Can I add another new set of node to expand my network
coverage?
A2: Yes. Open TCL WiFi App, tap Sengs in the lower-right
corner, tap Add MS1G, and follow the on-screen instrucons
to add.
Q3: How to restore my network to factory sengs?
A3: With your nodes powered on, hold the RST buon of your
primary node down using a paper clip for about 6 seconds,
release when the LED indicator blinks fast. Your network is
reset successfully when the LED indicator lights solid on then
blinks fast again. And all nodes are restored to factory sengs.
Q4: My 2.4 GHz WiFi-enabled devices, such as a home security
camera, cannot connect to my TCL WiFi network. What should
I do?
A4:
Step 1. Connect your smart phone used for setup to your TCL
WiFi network.
Step 2. Run TCL WiFi App, tap Sengs, Smart Assistant,
and Enable. Your smart phone connects to the 2.4 GHz WiFi
network.
Step 3. Use the smart phone to set up your 2.4 GHz WiFi-
enabled device guided by its App.