Installation guide

OmniAccess OAW-AP70: Installation Guide
20 Part 031644-00 May 2005
4 Save the configuration and reboot the OmniAccess
OAW-AP70.
Once the OmniAccess OAW-AP70 boots, disconnect it and mount it in its
intended service location (see Provisioning Access Points on page 21).
X, Y
Coordinates
For each access point and air monitor, measure its X
and Y position (in feet) relative to the bottom-left corner
of the building plan as seen from overhead. For
example:
Use the same fixed point and orientation for all floors in
a building.
apboot> save
apboot> boot
0,0 126
98
X
418 ft.
Y
262 ft.