Installation guide

Port Specifications 31
APPENDIX A
Port Specifications
FE Port
The 10/100 Mbps Ethernet (FE) port is located on the right-hand
side of the OmniAccess OAW-AP70 and has an RJ-45 female
connector. The port pin-outs are shown in Figure A-1 :
FIGURE A-1 OmniAccess OAW-AP70 FE Port
The appropriate cable depends on the level of connectivity
required of the FE port:
z If the connecting device supports Serial and Power Over
Ethernet (SPOE), use an 8-conductor, Category 5 UTP,
straight-through FE cable with a male RJ-45 connector.
The Alcatel 6000 (with Line Card OAW-LC-2G24FP), the Alcatel
2400, and the Alcatel 800 support SPOE.
z If the connecting device supports only Power Over Ethernet
(POE, including IEEE 802.3af POE as well as “inline” or “mid-
span” POE devices), use an 8- or 4-conductor, Category 5
UTP, straight-through FE cable with male RJ-45 connectors.
z If the connecting device does not support Serial or POE, use a
4- or 8-conductor, Category 5 UTP, FE cable with male RJ-45
connectors. The port detects MDI/MDX and automatically
adjusts for straight-through or crossover cables.
AP70
10/100 Mbps Ethernet
RJ-45 Female
Pin-Out
*POE optional
**Serial optional
Serial RxD**
Serial RGND** (POE positive*)
Serial TxD**
Serial TGND** (POE negative*)
1
2
3
4
5
6
7
8
ETH Tx+ (POE negative*)
ETH Tx– (POE negative*)
ETH Rx+ (POE positive*)
ETH Rx– (POE positive*)
Direction
Input
Output