User guide

Managing the Directory Structure (Non-Redundant) Managing CMM Directory Content
page 5-14 OmniSwitch 6250/6450 Switch Management Guide May 2012
To reboot the switch from the certified directory, enter the reload command at the prompt:
-> reload
This command loads the image and configuration files in the certified directory into the RAM memory.
These files control the operation of the switch.
Note. When the switch reboots using the reload command, it boots up from the certified directory. Any
information in the running configuration that has not been saved to the working directory is lost.
Scheduling a Reboot
It is possible to cause a reboot of the primary or secondary CMM at a future time by setting time
parameters in conjunction with the reload command, using the in or at keywords.
To schedule a reboot of the primary CMM in 3 hr and 3 min, you would enter:
-> reload primary in 3:03
To schedule a reboot of the primary CMM for June 30 at 8:00 pm, you would enter:
-> reload primary at 20:00 june 30
Note. Scheduled reboot times has to be entered in military format ( a twenty-four hour clock).
Cancelling a Scheduled Reboot
To cancel a scheduled reboot, use the cancel keyword. A cancel command can be specified for a primary
reboot, a secondary reboot, or all currently scheduled reboots. for example, to cancel the primary reboot
set above, enter the following:
-> reload primary cancel
To cancel all scheduled reboots with a single command, enter the following:
-> reload cancel