System information

Using the System Configuration Program

2-46

802.1Q VLAN Static Table Configuration

Use this screen to create a new VLAN or modify the settings for an existing VLAN.

You can add/delete port members for a VLAN from any unit in the stack as a tagged

or untagged member. Or you can prevent a port from being automatically added to a

VLAN by the GVRP protocol.

Alcatel OmniStack 6124

< 802.1Q VLAN Static Table Configuration >

VID VLAN Name Status

------------------------------

1 Active

Unit Egress Ports Forbidden Egress Ports

1. 111111111111 111111111111 11-- 000000000000 000000000000 00--

2. ------------ ------------ ---- ------------ ------------ ----

3. ------------ ------------ ---- ------------ ------------ ----

4. ------------ ------------ ---- ------------ ------------ ----

5. ------------ ------------ ---- ------------ ------------ ----

6. ------------ ------------ ---- ------------ ------------ ----

Unit Untagged Ports

1. 111111111111 111111111111 11-- VID : 1

2. ------------ ------------ ---- [Show]

3. ------------ ------------ ---- [More]

4. ------------ ------------ ---- [New]

5. ------------ ------------ ----

6. ------------ ------------ ----

Use <TAB> or arrow keys to move, other keys to make changes.

Parameter Description

VID The ID for the VLAN currently displayed.

Range: 1-2048

VLAN Name A user-specified symbolic name for this VLAN.

String length: Up to 8 alphanumeric characters

Status Sets the current editing status for this VLAN as: Not in Service, Destroy or Active.

Unit Stack unit.

Egress Ports Set the entry for any port in this field to “1” to add it to the displayed VLAN, or “0”

to remove it from the VLAN.

Forbidden Egress Ports Prevents a port from being automatically added to this VLAN via GVRP. Note that

GVRP is not supported in the current firmware release.

Untagged Ports You can add a port to the displayed VLAN as an untagged port by setting this field

to “1” or as a tagged port by setting it to “0.” This field is only enabled if the

corresponding port has been added to the displayed VLAN as an “Egress Port.”

[Show] Use <TAB> or the arrow keys to select this field, then press <Enter> to display

settings for the VLAN specified in the VID field immediately above.

[More] Use <TAB> or the arrow keys to select this field, then press <Enter> to display the

next consecutively numbered VLAN.

[New] Use <TAB> or the arrow keys to select this field, then press <Enter> to set up the

screen for configuring a new VLAN.