Operation Manual

Introduction
Assigning IP addresses
to the STHome
STHome and multiple
IP addresses
'IP address' table
6 Networking Services - IP, DHCP and DNS
59 / 104
3EC 17058 AAAA TCZZA Ed. 04
6.2 Speed Touch Addresses
Like any other member of a LAN, the STHome must be locally
identified by an IP address to be able to communicate with other
local LAN devices.
This section deals with the IP address configuration of the
STHome for local communication only.
IP addresses can be assigned to the STHome in several ways.
Summarized, following IP address types exist:
 The default IP address: 10.0.0.138
 IP addresses assigned via the 'Initial Setup' page
 IP addresses assigned via a 'PingofLife
 IP addresses assigned to the STHome via DHCP.
As the STHome IP layer supports logical multihoming (one
interface supporting multiple IP addresses), both statically and
dynamically configured IP address(es) can be active at the same
time.
On the STHome 'Routing' page the 'IP address' table summarizes
all IP addresses configured on any of the STHome interfaces.