User Manual

MAKING A PHONE CALL
Dial number
Caller ID (CID) is a service available from your local telephone company.
For Caller ID to work on this system, you must subscribe to Caller ID service.
This unit can receive caller ID without any setting. Your Caller ID information
may include the phone number, date and time.
CALLER ID FEATURES
REVIEWING INCOMING CALLS
CONTRAST/MUTE
In off-hook state, user can press the MUTE button to access mute function.
When CONTRAST/MUTE is on, the CONTRAST/MUTE indicator will show on
the screen.
Press the MUTE button to exit mute function and resume normal
conversation.
In on-hook state, user can press the MUTE button to selection the LCD
Contrast ( 1~5 chioce,default 3).
P=>T DIAL MODE
In PULSE dialing mode, press[*] button to access TONE service.
Last number redial
REDIAL
CONTRAST LEVEL ADJUSTMENT
In on-hook state, press the MUTE button to adjust the display contrast level.
TROUBLESHOOTING TIPS
No Dial Tone
· Check all cabling to make sure that all connections are secure and not
damaged.
· Check hook switch: Does it fully extend when handset is lifted from cradle?
No Display
· Replace the batteries.
· Check for proper battery installation.
Model ALCATEL T70-EX
A/W No.: 10000669 Rev.1 (EN)
14-08
Printed in China
DIAL BACK A CALLER ID NUMBER
Select the caller number
The number shown will be dialed
Press
" 0 " key 2 seconds
PCODE will be added to
the front of number shown
Select the caller number
The number shown will be dialed
REVIEWING OUTGOING NUMBERS
DIAL BACK AN OUTGOING NUMBER
The number shown will be dialed
MEMORY OPERATIONS
DELETING A CALLER ID NUMBER
Select the number
Dial number
CASE 1
The number shown will be dialed
CASE 2
CASE 1
The number shown will be dialed
CASE 2
Reviewing Incoming Call Log
CASE 1
CASE 2
No Information is Shown After the Phone Rings
· Have you subscribed to Caller ID service from your local telephone
company?
· Be sure to wait until the second ring before answering.
Phone Dials in Pulse with Tone Service
· Make sure T/P DIAL MODE is set to TONE DIAL.
Phone Won't Dial Out with Pulse Service
· Make sure T/P DIAL MODE is set to PULSE DIAL.
Phone Does Not Ring
· You may have too many extension phones on your line. Try to unplug
some extension phones.
· Check for dial tone. See troubleshooting tips for no dial tone.
Incoming and Outgoing Voice Volume Low
· Are other phones off hook at same time? If so, this is normal condition as
volume drops when additional phones are used at once.
· Check the handset receiver or speaker volume.
GENERAL PRODUCT CARE
To keep your phone working and looking good, follow these guidelines:
· Avoid putting it near heating appliances and devices that generate
electrical noise (for example. Motors or fluorescent lamps).
· DO NOT expose to direct sunlight or moisture.
· Avoid dropping and other rough treatment to the unit.
· Clean with a soft cloth.
The store where you bought your telephone can also provide you with
information and after-sales support.
Used equipment must be disposed of in compliance with
current environment protection regulations.
You should return it to your reseller or dispose of it in an
approved recycling center.
OR
OR
OR
OR OR
OR
OR
OR
OR
OR
OR OR
OR OR
STORING A TELEPHONE NUMBER
Dial number Memory location
M1~M8
OR
STORING INCOMING CALL NUMBER
Select the number Memory location
M1~M8
OR
STORING OUTGOING NUMBERS INTO MEMORY
Select the number
Memory location
M1~M8
OR
CASE 1
DIALING A MEMORY LOCATION
Select a Memory Location
CASE 2
Memory Location
+
M1~M8
OR OR
OR
+
M1~M8
OR
OR
DELETING A MEMORY LOCATION
Select a Memory
Location
Press and Hold
2 Seconds
+
M1~M8
OR
OR OR
Select the caller number
Add number to the front
The number shown will be dialed
CASE 3
PHONE OPERATION
RECEIVING A PHONE CALL
Answer Call End Call
End Call
Ringing
CASE 1
Answer Call
Ringing
CASE 2
End CallAnswer Call
Ringing
CASE 3
End Call
Answer Call
Ringing
CASE 4
· Never use a strong cleaning agent or abrasive powder because this will
damage the finish.
· Retain the original packaging in case you need to ship it at a later date.
www.alcatel-home.com