Quick Start Guide

Full green: Proper functioning
Note: Both wires are neutral, so it doesn’t matter which color wire
goes into which of the two ports. However, make sure the open
wire ends are not touching each other.
1. Unwind your Garage Spool Wiring just enough to reach the back
of your Garager 2 model, while leaving the remaining wire
intact.
2. Take the loose end of your Garage Spool Wiring and repeat Step
7 instructions for 7.1 and 7.2.
3. Insert the now exposed wires into the 1
st
and 2
nd
terminals on
the back of the Garager 2 device. Again, you may need a small
pointed tool to push down on the buttons to release and insert
the wiring.
4. Once inserted properly, the LED status indicator light will turn
from Blue to
Step 8
Connect Wires to Garager 2
Where: In the Garage
- 16 -