Mini 3D Sound Bar and Subwoofer User’s Guide If you need assistance Toshiba’s Support Web site support.toshiba.
Table of contents Introduction ....................................................................................... 8 Safety icons ........................................................................................ 8 Box contents ....................................................................................... 8 Mini 3D Sound Bar speaker system controls ..................................... 9 Remote control ..................................................................................
Safety precautions The lightning flash with an arrowhead symbol, within the equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in this User’s Guide.
Important safety instructions 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 14. Do not overload wall outlets; extension cords, or integral convenience receptacles as this can result in a risk of fire or electric shock. 15.
About the remote control battery DO NOT INGEST BATTERY, CHEMICAL BURN HAZARD The remote control supplied with this product contains a coin / button cell battery. If the coin / button cell battery is swallowed, it can cause severe internal burns in just 2 hours and can lead to death. Keep new and used batteries away from children. If the battery compartment does not close securely, stop using the product and keep it away from children.
USA Federal Communications Commission Statement FCC Compliance Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Interference This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Precautions On Safety On Recycling Do not handle the adapter power cord with wet hands. When connecting or disconnecting the adapter power cord, grip the plug and not the cord itself. Pulling the cord may damage it and create a hazard. When you are not going to use the unit for a long period of time, disconnect the adapter power cord. This unit’s packaging materials are recyclable and can be reused. Please dispose of any materials in accordance with your local recycling regulations.
Sonic Emotion is a registered trademark of sonic emotion ag. All other brand and product names are trademarks or registered trademarks of their respective companies. Introduction Safety icons This guide contains safety instructions that must be observed to avoid potential hazards that could result in personal injuries, damage to your equipment, or loss of data.
Mini 3D Sound Bar Speaker System Controls Front panel 1 2 3 4 5 6 7 (Sample Illustration) Front panel Item Description Function 1 INPUT button Selects sources (OPTICAL, COAXIAL, AUX IN or LINE IN). 2 Bluetooth® button Selects Bluetooth® mode. 3 VOLUME +/- buttons Adjusts the volume level. 4 Power button Turns the unit on or restores it to the standby mode. 5 Remote sensor Receives the remote control’s signals. 6 Bluetooth® indicator Blinking blue: pairing. Solid blue: paired.
Back panel 8 9 10 11 12 13 14 (Sample Illustration) Back panel Item Description Function 8 DC IN jack Connection for the supplied AC adaptor. See “Connecting the AC adapter” on page16 9 SUBWOOFER jack Connection for the subwoofer. See “Connecting the subwoofer” on page15 10 OPTICAL jack Connection for an optical audio output device using an optical audio cable (not supplied).
Remote control buttons Item Description Function: 1 2 1 POWER Press to turn the Sound Bar ON or put it in standby mode. 2 MUTE 5 6 Press to turn the sound off; press again to turn the sound back on. 3 VOLUME +/- Press to adjust the volume level. 9 4 INPUT Press to select the audio source. 5 PAIRING Press to select Bluetooth® mode. 6 3D Press to toggle 3D mode on and off. 7 MOVIE Press to select the Movie audio mode. 8 MUSIC Press to select the Music audio mode.
(Sample Illustration) Remote control - changing the battery To Change Battery 1 2 Open the battery door. Insert one CR2025 (3V) size battery. Never throw the battery into a fire. Doing so may cause the battery to explode. The remote control supplied with this product contains a button cell battery that could be ingested by children. Do not leave button cell batteries within reach of children. Do not expose the remote sensor to a strong light source such as direct sunlight or other illumination.
NOTE If the remote control does not operate correctly, or if the operating range is reduced, replace the battery with a new one. If the battery is dead or if you will not be using the remote control for a long time, remove the battery to prevent battery acid from leaking into the battery compartment. Do not expose the battery to excessive heat such as from direct sunlight or fire.
Mini 3D Sound Bar Speaker System Connections Getting sound from external sources Follow these instructions to route external audio signals from devices such as a TV to the Mini 3D Sound Bar via the OPTICAL, COAXIAL, L/R AUX IN and LINE IN jacks. Using OPTICAL jack 1 Connect an optical cable (not supplied) from the OPTICAL jack on the Mini 3D Sound Bar to the OPTICAL OUT jack on a TV, set-top box, DVD, or other audio device. 2 Press the INPUT button to switch to the OPTICAL input.
Using L/R AUX IN jacks 1 Connect an RCA audio cable (supplied) from the L/R AUX IN jacks on the Mini 3D Sound Bar to the AUDIO OUT jacks on a TV, set-top box, DVD, or other audio device. 2 Press the INPUT button to switch to the AUX IN inputs. RCA audio cable (supplied) (Sample Illustration) Analog audio cable connection Using the 3.5mm LINE IN jack 1 Connect an 3.5mm audio cable (not supplied) from the LINE IN jack on the Mini 3D Sound Bar to the LINE OUT jack on an audio device.
Connecting the AC adapter Using an AC adapter other than the one supplied with the unit may damage the unit. AC Adapter (supplied) AC Power Cord (supplied) (Sample Illustration) Connecting the AC Adapter The included AC adapter is for use with this unit only. Do not use it with other equipment. If you are not going to use the unit for an extended period of time, disconnect the AC adapter from the wall outlet.
Audio Playback mode Press the Audio Mode buttons on the remote control to select the audio mode of your preference via the Movie, Music, or Game button on your remote control. (Sample Illustration) Audio playback modes Sonic Emotion Absolute 3D is the listening experience. Absolute 3D uses wave field synthesis and sound field reproduction to eliminate the physical dimensions of a room and transform it into a virtual sound field.
Playback via Bluetooth®-enabled devices 1 Press the button to switch the Mini 3D Sound Bar to enable Bluetooth mode. The blue indicator illuminates and flashes, meaning that it is searching for available Bluetooth-enabled devices. 2 Turn on the Bluetooth mode of your other Bluetooth-enabled device (e.g. Smart phone, tablet, notebook etc.). Your other device will search for the Toshiba Mini 3D Sound Bar.
Troubleshooting Problem Solution The Mini 3D Sound Bar does not turn on. Make sure that the AC adapter is connected to the Mini 3D Sound Bar, and that it is plugged into a wall socket. Press the Power ( ) button located on the top of the Mini 3D Sound Bar, and check to see if the power indicator is glowing green. No sound from the Mini 3D Sound Bar Press the Volume +/- buttons of the Mini 3D Sound Bar. Make sure that the source you have selected is sending audio.
Specifications Sound Bar Power requirements 19 volts DC, 3.42A Power output 10watts x 4 (per channel at 4ohms, 1 kHz/THD10%) Impedance 4 ohms Dimensions (width x height x depth) 11.4” x 2.8” x 3.9” (290 x 72 x 100mm) Weight 1.93 lbs (0.875kg) Frequency Response 350Hz - 15KHz S/N ratio >55dB Distortion <10% Subwoofer Power output 20W 8 ohms 100Hz/THD10% Impedance 8 ohms Dimensions (width x height x depth) 8.7” x 8.7” x 8.7” (220 x 220 x 220mm) Weight 6.25 lbs (2.
