User's Manual

3
System connections
Remote Control
Battery Replacement
When the battery becomes weak, the operating distance of the
remote control will be greatly reduced and you will need to replace
the battery.
Note:
If the remote control is not going to be used for a long time, remove
the battery.
WARNING:
• Do not dispose of the battery in a re or it may leak and/or explode.
• Batteries should not be exposed to excessive heat such as
sunshine, fire or the like.
CAUTION:
Danger of explosion if battery is incorrectly replaced. Replace only
with the same or equivalent type.
Using the Remote Control
• Point the remote control at the REMOTE SENSOR located on the
unit.
• When using this unit in very bright light, the infrared REMOTE
SENSOR may not work properly.
To Change Remote Battery
1. Open the battery door. 2. Insert 2 AAA size batteries.
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with a dry cloth.
7. Do not block the ventilation openings. Install in accordance with
the manufacturer's instructions.
8. Do not install near any heat sources such as radiators, heat
registers, stoves, or other apparatus (including amplifiers) that
produce heat.
9. Do not defeat the safety purpose of a polarized or grounding -
type plug. A polarized plug has two blades with one wider than
the other. A grounding type plug has two blades and a third
grounding prong. The wide blade or the third prong are provided
for your safety. If the provided plug does not fit into your outlet,
consult an electrician for replacement of the obsolete outlet.
10. Protect the power cord from being walked on or pinched
particularly at plugs, convenience receptacles, and the point
where they exit from the apparatus.
11. Only use attachments/accessories specified by the manufacturer.
12. Use only with a cart, stand, tripod, bracket, or table specified
by the manufacturer, or sold with the apparatus. When a cart is
used, use caution when moving the cart/apparatus combination
to avoid injury from tip-over.
13. Unplug this apparatus during lightning
storms or when unused for long periods of
time.
14. Refer all servicing to qualified service
personnel. Servicing is required when
the apparatus has been damaged in
any way, such as the AC power cord or
plug is damaged, liquid has spilled or
objects have fallen into the apparatus,
the apparatus has been exposed to rain or moisture, does not
operate normally, or has been dropped.
IMPORTANT SAFETY
INSTRUCTIONS
Precautions
• This compact disc player uses a laser to read the music on the disc.
The laser mechanism corresponds to the cartridge and stylus of a
record player. Although this product incorporates a laser pick-up
lens, it is completely safe when operated according to directions.
• Discs rotate at high speed inside the player. Do not use damaged,
warped, or cracked discs.
• Do not touch the pick-up lens which is located inside the disc
compartment. To keep dust from collecting on the pick-up lens, do
not leave the compartment door open for an extended period of
time. If the lens becomes dirty, clean it with a soft brush, or use an
air blower brush designed for camera lenses.
Headset safety
• Have a Blast-Just Not in your eardrums! Make sure you turn down
the volume on the unit before you put on headphones. Increase
the volume to the desired level only after headphone are in place.
• Do not play your headset at high volume. Hearing experts warn
against extended high-volume play.
• If you experience ringing in your ears, reduce volume or
discontinue use.
• You should use with extreme caution or temporarily discontinue
use in potentially hazardous situations. Even if your headset is an
open-air designed to let you to hear outside sounds, do not turn up
the volume so high that you are unable to hear what is around you.
• Excessive sound pressure from earphones and headphone can
cause hearing loss.
Safety Instructions
Portable Cart Warning
Connect the speakers to the R (R+, R-) terminals and the L (L+, L-)
terminals.
Note:
Connecting speakers other than
the speakers supplied with the
unit may damage the unit.
CAUTIONS:
• Ensure that the power supply in your house complies with that
indicated on the identification sticker located on the back of your
unit (AC 120V ~ 60Hz).
• If you are not going to use the unit for a long time, disconnect the
AC power plug from the wall outlet.
• This unit is designed for continuous use. Switching o the unit
to standby mode does not disconnect it from the power supply.
To completely isolate the equipment, remove the plug from the
power outlet as some components remain connected to the
electrical supply.
Right
Left
Silver cord (+)
Silver (Line dot) cord (-)
EN